|本期目录/Table of Contents|

[1]陈之翀,陈献,费兆阳,等.HCl氧化固定床反应器二维模型验证与管径影响模拟分析[J].南京工业大学学报(自然科学版),2016,38(06):39-46.[doi:10.3969/j.issn.1671-7627.2016.06.007]
 CHEN Zhichong,CHEN Xian,FEI Zhaoyang,et al.Verification of two-dimensional model and analysis of tube diameter on performance of fixed bed reactor for HCl oxidation[J].Journal of NANJING TECH UNIVERSITY(NATURAL SCIENCE EDITION),2016,38(06):39-46.[doi:10.3969/j.issn.1671-7627.2016.06.007]
点击复制

HCl氧化固定床反应器二维模型验证与管径影响模拟分析()
分享到:

《南京工业大学学报(自然科学版)》[ISSN:1671-7627/CN:32-1670/N]

卷:
38
期数:
2016年06期
页码:
39-46
栏目:
出版日期:
2016-11-15

文章信息/Info

Title:
Verification of two-dimensional model and analysis of tube diameter on performance of fixed bed reactor for HCl oxidation
文章编号:
1671-7627(2016)06-0039-08
作者:
陈之翀1陈献1费兆阳12汤吉海1崔咪芬1乔旭12
1.南京工业大学 化工学院,江苏 南京 210009; 2.南京工业大学 材料化学工程国家重点实验室,江苏 南京 210009
Author(s):
CHEN Zhichong1CHEN Xian1FEI Zhaoyang12TANG Jihai1CUI Mifen1QIAO Xu12
1.College of Chemical Engineering,Nanjing Tech University,Nanjing 210009,China; 2.State Key Laboratory of Materials-Oriented Chemical Engineering,Nanjing Tech University,Nanjing 210009,China
关键词:
拟均相二维模型 径向温度梯度 灵敏度分析
Keywords:
two-dimensional pseudo-homogeneous model radial temperature difference sensitivity analysis
分类号:
TQ124.4
DOI:
10.3969/j.issn.1671-7627.2016.06.007
文献标志码:
A
摘要:
本文建立了HCl催化氧化拟均相二维固定床反应器模型,通过单管实验验证模型的可靠性。分别考察在富氧及贫氧条件下管径对固定床反应器性能的影响,并在最大允许管径条件下,对操作参数进行灵敏度分析。结果表明:当反应管径增大时,由于径向传热能力的减弱,引起了显著的径向温度梯度,但在计算范围内,未出现明显的浓度梯度。当HCl与O2的流量之比(F(HCl)/F(O2))=6和1时,反应器最大允许管径分别为45 和32 mm,反应管入口温度和换热介质温度均不宜超过380 ℃,最佳m/F(HCl)分别为4 228和1 923 g·min/mol,在此条件下,每克催化剂上Cl2产率分别达到0.34和10.8 g/h。
Abstract:
A two-dimensional pseudo-homogeneous model was developed to simulate a fixed bed reactor for HCl oxidation.The model proved to be reliable by comparing calculated results with experimental ones.Effects of tube diameter on performance of fixed reactor under rich and lean oxygen atmosphere were investigated with the sensitivity analysis.Results showed that with widening tube diameter,an evident radial temperature difference of catalytic bed was observed owing to the decrease of radial heat transport capacity,but no evident concentration difference was found.The upper limit tube diameters were 45 mm(F(HCl)/F(O2)=6)and 32 mm(F(HCl)/F(O2)=1)respectively.The upper limit of inlet temperature and heat transferring medium temperature were 380 ℃ for both F(HCl)/F(O2)=6 and F(HCl)/F(O2)=1.Under optimal m/F(HCl)of 4 228 g·min/mol(F(HCl)/F(O2)=6)and 1 923 g·min/mol(F(HCl)/F(O2)=1),Cl2 productivity were 0.34 g/h and 10.8 g/h respectively.

参考文献/References:

[1] PEREZ-RAMIREZ J,MONDELLI C,SCHMIDT T,et al.Sustainable chlorine recycling via catalyst HCl oxidation:from fundamentals to implementation[J].Energy & environmental science,2011,4(12):4786.
[2] SEKI K.Development of RuO2/rutile-TiO2 catalyst for industrial HCl oxidation process[J].Catalysis surveys from Asia,2010,14(3/4):168.
[3] 陈智涛,韩明汉,魏飞,等.氯化氢催化氧化制氯气工艺过程[J].过程工程学报,2008,8(5):937.
[4] 杨成武,曹烁,左宜赞,等.氯化氢催化氧化制氯气催化剂的失活与再生[J].过程工程学报,2012,12(2):349.
[5] 陈献,乔旭,汤吉海,等.氯化氢氧化反应器的研究进展[J].现代化工,2007,27(增刊1):134.
[6] 岩永清思,铃田哲也,森康彦,等.氯的制造方法:1344225[P].2002-04-10.
[7] YASUHIKO M E.Reactor for producing chlorine and process for producing chlorine:US20100296998[P].2010-11-25.
[8] MLECZKO L,SCHIÜTER O F K,SCHUBERT S,et al.Process and apparatus for the production of chlorine by gas phase oxidation:US20090304573[P].2009-12-10.
[9] TANG J H,CHEN X,FEI Z Y,et al.HCl Oxidation to recycle Cl2 over a Cu/Ce composite oxide catalyst:intrinsic kinetic study[J].Industrial & engineering of chemistry research,2013,52(34):11897.
[10] FEI Z Y,LIU H Y,DAI Y,et al.Efficient catalytic oxidation of the HCl to recycle Cl2 over the CuO-CeO2 composite oxide supported on Y type zeolite[J].Chemical engineering journal,2014,257:273.
[11] FEI Z Y,XIE X X,DAI Y,et al.HCl oxidation for sustainable Cl2 recycle over the CexZr1-xO2 catalyst:effects of Ce/Zr ratio on activity and stability[J].Industrial & engineering of chemistry research,2014,53(50):19438.
[12] 谢兴星,费兆阳,戴勇,等.铈基复合氧化物的结构及其HCl催化氧化性能[J].分子催化,2014,28(6):507.
[13] 袁杰,费兆阳,陈献,等.流化床串联多段绝热床HCl氧化反应器模拟优化[J].化学工程,2015,43(2):73.
[14] 马沛生.化工数据[M].北京:中国石化出版社,2003:129-338.
[15] 朱炳辰.催化反应工程[M].北京:中国石化出版社,1999:312-388.
[16] LEVA M.Fluid flow through packed tubes[J].Chemical engineering,1949,56(5):115.
[17] SOHAL M S,EBNER MATTHIAS A,SABHARWALL P,et al.Engineering database of liquid salt thermophysical and thermochemical[Z].[S.l.]:U.S.Department of Energy Office of Nuclear Energy,2010.

备注/Memo

备注/Memo:
收稿日期:2015-04-20
基金项目:国家科技支撑计划(2011BAE18B01); 国家自然科学基金(21306089); 江苏省高校自然科学基金面上项目(13KJB530006)
作者简介:陈之翀(1990—),男,上海人,硕士,主要研究方向为反应工程; 乔旭(联系人),教授,E-mail:qct@njtech.edu.cn.
引用本文:陈之翀,陈献,费兆阳,等.HCl氧化固定床反应器二维模型验证与管径影响模拟分析[J].南京工业大学学报(自然科学版),2016,38(6):39-46..
更新日期/Last Update: 2016-12-20